Or you could slice a "port" in the side of the box to allow the coasters to stick through .5" . On Tue, Feb 17, 2009 at 1:42 PM, Elliott C. Evans <eeyore@xxxxxxxx> wrote: > Nick Lamicela wrote: >> >> I think to fit the coasters in the new LooneyLabsGameBox, >> you'd have to cut them in half and tape-hinge them together > > Nah. The coasters are just 4" tall, and the box is 3.5" tall. > The coasters are will fit in a new box if you trim 1/4"from > each edge of each coaster. This cuts off the very tip of the > triangles, but leaves quite enough to be useful. > > -- > Elliott C. "Eeyore" Evans > eeyore@xxxxxxxx > _______________________________________________ > Icehouse mailing list > Icehouse@xxxxxxxxxxxxxxxxxxxx > http://lists.looneylabs.com/mailman/listinfo/icehouse > -- Sam Zitin Director of Information Management Alpha Epsilon Pi Fraternity Office:317-876-1913 Cell: 317-710-0925